Zhangjiagang Xiecheng Mechanical Equipments Co., Ltd.

CJMFH 1300 / 1600-II:

1) Advantages:

a) High speed of finishing products: reaches 4-5m/min because it's not

subjected to the PE extruding machine's control, thus its cost for each

square is comparatively low

b) High yield rate, because all the unqualified goods can be reproduced until



it's qualified

2) Disadvantage: high cost in warming up the extruding machine and rolling up

the PE plates



These two kinds of lines are the same from the preset macromolecule film to the finished

products plat. They are automatic to set the PE plate of certain strength



to the preset annulus to make the film combined with the plate. Then this

combined material will be sent to be combined with the pre-warmed aluminum

roll.



After several times' combination and level off, and if it's molded, it's then sent



to the cool oven for cooling. Then the cooled plat will be covered by a protecting



coat and sent to the trimming machine then cut according to the customer's requirements.





Considering of the above advantages and disadvantages, we recommend the customer

to analyze his own condition and the benefits so as to choose the



proper style of this machine. On the other hand, our company is capable of

designing new machines according to customers' requirements.